Bug with build 2222

[MikeC]

Just upgraded to build 2222.

This version does not load registry tabs defined with an .ini file in the command line. Instead, all the tabs are for C:\. This worked just fine in the prior version.

[Mathias (Author)]

Only tab showing REG: that fails ?

I think it has to do with the new FileSystem scanning engine. I will check.

[MikeC]

Yes, only registry tabs fail. Tabs for normal folders (a separate invocation of MC) work fine (and faster!).

[AlanJB]

I load my tabs from a .mctab file and the REG: tab loads OK...

[Mathias (Author)]

But if you use a startup file
Eg
MultiCommander.exe -F=MyTabs.ini

It does not work for REG:  , I  Just confirmed it.
It works if the path have been browsed before.. There is an error when going to a subpath on a virtual device where parent folder is not browsed before..  (and REG: is virtual. )


To bad MikeC did not run beta version, then I would  have found this issue before

But it is only an issue with startup.. Normaly you will start at REG: and browse you way down. And that work

[MikeC]

Build 2225 fixed the problem.

Thank you for your prompt attention to it!!