Multi Commander > Support and Feedback

How to always start with 50%/50% panels?

(1/1)

Klaas Hobo:
I always have to re-adjust my panels to 50%/50% when starting MC. Where can I set that the % of panel width is always 50%/50%?

Also I would like to be sure then that column with is also sizing according to panel width (that is wider when panels width get bigger) and where to configure that?

Jungle:

--- Quote from: Klaas Hobo on April 17, 2024, 08:32:05 ---I always have to re-adjust my panels to 50%/50% when starting MC. Where can I set that the % of panel width is always 50%/50%?
--- End quote ---

There's an option under Menu Configuration > Core settings > Layout > Application layout > Panel Tab > Remember split size
With this option disabled MC should always restore 50/50 ratio


--- Quote from: Klaas Hobo on April 17, 2024, 08:32:05 ---Also I would like to be sure then that column with is also sizing according to panel width (that is wider when panels width get bigger) and where to configure that?
--- End quote ---

Menu Configuration > Explorer panel settings > Display > Sorting and columns > Autosize columns

Klaas Hobo:
Thanks Jungle,
Remember split size;  I was thinking the other way around, not configuring it is better ;-)
And columns autosize is what I will try out for a while. Looks good thoug!

Fritz:
Hallo,
ich nutze Multicommander seit Jahren und suche eine Möglichkeit die Spalten automatisch an die Fenstergrösse anzupassen. Die untenstehende Einstellung habe ich schon lange aktiv, trotzdem kommt es immer wieder vor das Multicommander nur eine Spalte anzeigt und den Rest versteckt - oder die Spalten völlig sinnlos aufteilt.
Kann ich da was besser einstellen ?
Danke für Tips, Fritz

Matthias515566:

--- Quote from: Fritz on August 15, 2024, 07:30:50 ---I've had the setting below active for a long time, but it still happens that MultiCommander only shows one column and hides the rest – or splits the columns completely nonsensically.
Is there anything I can adjust better?

--- End quote ---
I simply disabled 'Autosize Columns' because I didn't like how it worked.

Navigation

[0] Message Index

Go to full version