Multi Commander > Support and Feedback

Build 3088 (bugs)

(1/1)

Slava:
Build 3088 (portable version, x64), that I was upgraded to yesterday, acts very strange and basically is unusable.
1. After start MC shows (at least some folders, for example, ...\AppData\Roaming) as an empty ones (see MC-2025-04-19 - 01.JPG).
2. After "Refresh" the contents is displayed (see MC-2025-04-19 - 02 (after Refresh).JPG), but problems continue.
3. After going into some subfolder (by double-clicking), there is no way to go back to the parent folder (by double-clicking on ..).
4. In addition to that Folder list sometimes shows duplicate names (see MC-2025-04-19 - 03.JPG).
5. Navigating to some other folders is possible, but the one that is mentioned in step 3 as a 'parent' one stays inaccessible.
Am I the only one that lucky?..

Stéphane P.:
Hello,

No you're not the only one.

I also have this strange behaviour on one computer at home.

@Mathias, are you aware of the problem ? Do you want us a vidéo of what is happening ?

Regards.

Mathias (Author):

--- Quote from: Stéphane P. on April 19, 2025, 21:04:39 ---Hello,

No you're not the only one.

I also have this strange behaviour on one computer at home.

@Mathias, are you aware of the problem ? Do you want us a vidéo of what is happening ?

Regards.

--- End quote ---

Yes it is the foldertree that mess with some new performance improvements in the filelist.
Will be fixed soon. I think I can fix it tomorrow when I'm back home

ks1:
I have very similar problems. I updated a few minutes ago.
I can navigate using the folder list and access files like that, but cannot use the 'go up' button to navigate through the folder structure. However, if I change the drive using the drive tab, then I can navigate the folders normally in that folder, but not the original. If I close MC whilst on that different drive, restart and go back to original drive, it sometimes lets me navigate that drive normally, but it seems very erratic.

Hope you can fix it soon. It's pretty unusable ATM.

I also found another possible problem. I went to downgrade the app so it was usable. The latest version was described as
MultiCommander_x64_Portable_(15.2.0.3077)
I download this and copy the files in to the correct folde. When I start MC it tells me there are other versions. I choose v 3086 as the latest available, but instead it updates to v3088,

Even if I mke a mistake, (I don't understand why I see dirferent versions available) an invitation to upgrade to 3086 should install 3086, not 3088.

Mathias (Author):
Where do you see 3086 ?? 

Navigation

[0] Message Index