« previous next »
Pages: [1]   Go Down

Author Topic: How to I save settings?  (Read 14249 times)

Masterblaster

  • Newbie
  • *
  • Posts: 1
    • View Profile
How to I save settings?
« on: December 23, 2012, 16:33:21 »
Once I get the tabs and such setup, I would like to save all the settings so they cannot change on exit.
I already Locked the tabs.
Is there a way I can not save settings on exit and save them at a specific time so they do not change?
Mostly I am referring to the layout.
Logged

Mathias (Author)

  • Administrator
  • VIP Member
  • *****
  • Posts: 4424
    • View Profile
    • Multi Commander
Re: How to I save settings?
« Reply #1 on: December 23, 2012, 16:55:34 »
No.. but you can specify a file as parameter to MC. and in that file you can configure the tabs you want MC to open.
See http://multicommander.com/docs/commandlineparameters


Logged

bobad

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: How to I save settings?
« Reply #2 on: December 26, 2012, 16:56:15 »
Can command line parameters be used to start with a single panel sized to to 100/0?

If not, is there another way to start with 1 panel set to 100/0?

Many thanks,,,
Logged

Mathias (Author)

  • Administrator
  • VIP Member
  • *****
  • Posts: 4424
    • View Profile
    • Multi Commander
Re: How to I save settings?
« Reply #3 on: December 26, 2012, 17:10:06 »
No.
Because it is not recommended to always run in 0/100 mode. Since a lot of features depends on what is showing in the "target" panel.
and if that is always hidden you might do something there without knowing and seeing it.

Logged
Pages: [1]   Go Up
« previous next »