Multi Commander Support Forum
Multi Commander => Support and Feedback => Topic started by: Sempervivum on November 10, 2014, 09:40:01
-
Hallo,
I would like that MC stores the current layout of the windows and the paths when it's terminated and reloads it when it is started again. Currently MC starts with a fixed setting I had previously set by the command line. In the meantime I have removed that parameters from the command line but MC continues to start with that settings.
Couldn't find any item in the settings that controls this.
Regards - Ulrich
-
In the meantime I could solve this problem. It was my fault: I had copied the link from the desktop to the autostart folder. Then I changed the command line on the desktop and wasn't aware that MC was started from the autostart with the old command line!
-
if i close the MC with tab like X:\common\serg and x: is a network folder
then i start МС that tab is like X:\ . go to the root
-
if i close the MC with tab like X:\common\serg and x: is a network folder
then i start МС that tab is like X:\ . go to the root
It reverts backwards in the path only if the path was not found. Or if a fixed path was force by commandline or startup settings files.
-
sorry
it backwards то С:
-
Network path are not remembered by default since it will halt MC for a while on startup if the network path is missing.
But you can change that in settings..
Explorer Panel Settings. uncheck "Save only path to localharddrive"
-
thanks alot