Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: shekky on September 08, 2016, 23:53:08

Title: Last drive letter no longer showing up on toolbar.
Post by: shekky on September 08, 2016, 23:53:08

I have a few mapped drives, but the last one (Z:) is not longer showing up in the drive toolbar.
I have the toolbar set to show on a separate line to make sure there is enough room for all the drives to show up.
I even removed a virtual drive that I had to see if there were maybe too many drives to for multi-commander to handle, but no luck.
It used to show up an update or so ago, but now it doesn't show up. This is a mapped network drive if that matters.

Title: Re: Last drive letter no longer showing up on toolbar.
Post by: shekky on September 08, 2016, 23:55:56

I had to re-connect the drive in windows before it would show up, which is strange because there are other disconnected network drives that do in fact show up in the toolbar.

Title: Re: Last drive letter no longer showing up on toolbar.
Post by: Mathias (Author) on September 14, 2016, 22:11:40

The issue is that if it gets disconnected.  Windows will not provide it to MC when it asks for all available drive letters at startup