Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: GlennVanB on January 04, 2020, 01:25:33

Title: Install failure--x64_(9.5.0.2570)
Post by: GlennVanB on January 04, 2020, 01:25:33

The latest version fails to install with no messages. The installer just doesn't respond! Two downloads--from Multi Commander site and Filepuma--bitwise identical. My system: Windows 10-64-bit, latest version, HP computer, Intel I-7, 16 GB RAM. Running as Administrator didn't work either.

Uninstalling prior version made no difference.

Glenn

Title: Re: Install failure--x64_(9.5.0.2570)
Post by: Mathias (Author) on January 04, 2020, 11:25:24

There should be no issues with installation. Nothing have changed in that. same as it been last couple of years.

"The installer just doesn't respond!"   what does that mean ?   does it not start at all.. Does it not continue when pressing next or what ?

Do you run special sandboxing or security software that can halt stuff from running ?

There is a portable version too that do not need any installation.. just unzip and run.

Title: Re: Install failure--x64_(9.5.0.2570)
Post by: GlennVanB on January 08, 2020, 03:29:33

Must just have been a fluke! Today it installed Ok.

What I meant earlier was that it didn't start at all--no sandbox, no unusual security--just came up and then vanished.

Thanks for a very nice tool!

Glenn