Multi Commander Support Forum
Multi Commander => Support and Feedback => Topic started by: Ulfhednar on April 23, 2013, 18:47:02
-
Is it possible to run a search on several drives? Is there some separator I can use?
i.e can I enter something to allow the 'look in' field to take multiple locations?
As far as I can tell if I search c:\ I must run a new search on d:\, & I cannot tell the search to search several drives sequentially.
-
Separator is ";"
Eg "D:\;E:\;F:\Stuff;G:\Folder42"
-
Thanks Mathias, given that you use that for multiple folder creation/naming I should have guessed....
Sorry for being a dummy! ;)
-
No worries.
Kind of my fault, since the documentation is kind of incomplete.
If I had more time I would improve the documentation since it is missing a lot. But writing documentation takes more time then one might think.
( I have now updated the online documentation with a quick note about this )
-
I imagine there is a lot hidden away in MC that I haven't found yet.
Hope you find time to get everything resolved.
Thanks for the effort you put into this prog. :)