1
Support and Feedback / Re: Default system dialogue for copy/move
« on: November 30, 2022, 13:08:44 »
Thank you very much!
News:
MultiCommander v14.2 is released!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Support and Feedback / Default system dialogue for copy/move
« on: November 28, 2022, 11:22:16 »
Hi,
I'm new to MC and really loving it. But for some time I'm looking for a setting to change the copy/move-dialogue to the system default. So that when I want to copy or move files it uses the standard windows copy procedure (or in my case TeraCopy) instead of the internal MC-dialogue. Is there any way to do this?
Best regards,
-Tim
I'm new to MC and really loving it. But for some time I'm looking for a setting to change the copy/move-dialogue to the system default. So that when I want to copy or move files it uses the standard windows copy procedure (or in my case TeraCopy) instead of the internal MC-dialogue. Is there any way to do this?
Best regards,
-Tim
Pages: [1]