Messages

1

Support and Feedback / Re: Save open tabs to current tab session on exit

« on: November 02, 2017, 04:21:53 »

Thanks, but using separate configurations pose another problem that I need to sync all other configuration between the installations. What I want is just to persist the open tabs, but since I open a lot of tabs (says 50-100 tabs) I want to split them into different windows and have those windows open/close independently. If this is not possible in multicommander I guess I can use autohotkey to automate it somehow.

2

Support and Feedback / Re: Save open tabs to current tab session on exit

« on: November 01, 2017, 12:22:19 »

By the way is there a way to run a multiscript just before closing multicommander? That way I can trigger the tabsession saving just before closing.

3

Support and Feedback / Re: Save open tabs to current tab session on exit

« on: November 01, 2017, 12:19:07 »

I tried running multicommander with the /INSTANCE parameter but it does not seem to work:

I run two instance of multicommander with these commands

multicommander.exe /INSTANCE=test
multicommander.exe /INSTANCE=test2

Then I close both windows. Then I run both commands again. But the multicommander windows that was run with /INSTANCE=test2 does not retain its tab list, instead it opens the same tab list as the first instance that was run with /INSTANCE=test.

4

Support and Feedback / Save open tabs to current tab session on exit

« on: October 31, 2017, 06:28:02 »

Hi,

Is it possible to save currently open tabs to the currently loaded tab session, on exit, without having to manually save the tab session?

I want to open several multicommander windows, and have each window resume its previous tab sets when it is opened again. Of course each window will have different tab session. But the problem I that I am not sure I will remember to save the session on exit, not to mention it will become a hassle having to repeatedly save the session before closing if that is what I always want.