Messages

1

Support and Feedback / Re: Cursor Location is not accurate or is mismatched

« on: February 25, 2025, 06:09:48 »

After I reopened the program, the issue was gone. So what do you think might have caused the issue to occur?

2

Support and Feedback / Re: Cursor Location is not accurate or is mismatched

« on: February 24, 2025, 07:21:27 »

The issue is that, in Windows 11, when I hover my cursor over any button in an active Multicommander (x64) window, the button is still unclickable.

3

Support and Feedback / Cursor Location is not accurate or is mismatched

« on: February 23, 2025, 19:39:56 »

While hovering my cursor to a button in Multi Commander, I noticed that the Cursor Location is not accurate or is mismatched, as shown in this recording:

4

Support and Feedback / The icon of a .jpg file won't automatically load

« on: September 22, 2024, 10:13:30 »

Hi, I noticed that for any picture that I took with my Samsung Android 13 phone, which is then automatically synced to my Onedrive's Camera Roll folder, it only appears as a .jpg that uses an icon of the Windows 11 built-in Photo app. This issue does not occur for .jpg files that are screenshots or are online images. I've attached an image for your reference:
 

5

Support and Feedback / Can't Open .jpg files

« on: May 23, 2024, 18:14:29 »

With MultiCommander v13.5 for windows 11, In a sub-folder in my microsoft Onedrive, I've been unable to open all .jpg files except two of them. I uninstalled and reinstalled Multicommander, but the problem still persists. I tried opening the same .jpg files in File Explorer and it worked fine. In addition to this, Multicommander has been unable to load the text in various toolbars properly without any obvious reason.