Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Pedrober

Pages: [1]
1
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 18:52:13 »
OK, SSE2 instructions are not supported.

2
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 18:25:41 »
I uploaded again the dump file, just to double check.

3
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 18:22:08 »
Apparently, SSE instructions are working...

4
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 18:18:12 »
Wait! I have found an utility. I'll test and I'll report.

5
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 18:16:50 »
Thank you very much for your message. The Phoenix BIOS doesn't show any reference to SSE instructions. Do you know an utility to test if they are on?

6
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 17:51:21 »
Thank you very much for your message. The processor is a 1,67 gigahertz AMD Athlon XP.

7
Support and Feedback / Re: Multicommander portable crashes upon start
« on: September 07, 2013, 14:20:29 »
Similar problem. I have uploaded the MCCrash.dmp file.

8
Support and Feedback / Slow mouse response
« on: August 31, 2012, 11:13:39 »
Not directly related, but mouse response is slow or, sometimes, doesn't work when I attempt to rename a file this way. My "Mouse configuration" settings are:
Click: No action
Double click: Open/Execute
Click and hold: Rename
Click and white: Rename
Any suggestion?

9
Support and Feedback / Re: Full pane width not preserved
« on: August 17, 2012, 15:01:33 »
OK, I understand. Anyhow, it's a minor inconvenience. I prefer to work in full panel width mode with several tabs...

10
Support and Feedback / Full pane width not preserved
« on: August 16, 2012, 20:16:06 »
I use full pane width but, unfortunately, after closing a session, the following session doesn't open in full pane mode. I suppose it's a bug.

Pages: [1]