1
Support and Feedback / Re: [FIXED] GVim as default editor
« on: September 27, 2011, 11:02:53 »
It works 
Thank you very much
Thank you very much
News:
MultiCommander v14.2 is released!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Feature Requests and Suggestions / Switch Tabs (Left->Right and Right->Left)
« on: August 06, 2011, 16:22:48 »
I would be a nice to have feature, shortcut to switch the tabs from side to side.
Thx
Thx
3
Support and Feedback / Re: GVim as default editor
« on: August 06, 2011, 16:18:53 »
Thank you very much 
Have a nice weekend
Have a nice weekend
4
Support and Feedback / [FIXED] GVim as default editor
« on: August 04, 2011, 15:56:42 »
Hello, I'm really enjoying your software so far
I wish to know how can I pass ${filepath} between "". As far as I know ${filepath} returns C:\My Documents\example.txt, this causes GVIm to open two files, one called C:\My and another called Documents\example.txt. I've tried "${filepath}" but it ignores the ".
Thank you very much,
I wish to know how can I pass ${filepath} between "". As far as I know ${filepath} returns C:\My Documents\example.txt, this causes GVIm to open two files, one called C:\My and another called Documents\example.txt. I've tried "${filepath}" but it ignores the ".
Thank you very much,
Pages: [1]