Author Topic: Userdefined Commands XML file  (Read 6441 times)

karthik

  • Active Member
  • ***
  • Posts: 56
    • View Profile
Userdefined Commands XML file
« on: March 26, 2014, 15:53:38 »
I made some changes in the Userdefined Commands XML file and I thought once I close and open MC, the changes will take effect. But to my surprise, when I closed and opened MC, none of my user defined commands show up in GUI but I see the XML file is intact. Is there any other place I need to make changes for MC to reload the XML file?

Mathias (Author)

  • Administrator
  • VIP Member
  • *****
  • Posts: 4271
    • View Profile
    • Multi Commander
Re: Userdefined Commands XML file
« Reply #1 on: March 26, 2014, 16:07:48 »
A restart of MC is all that is needed.  But did you changed the correct file ?
It is the file that is located in the users private config location.. not in the install folder.  (Unless you run portable version)

Type ":goconfig" in MC to go to the User Config location.
Also if you edit the file manually make sure you do not mess up the XML tags. You can verfiy the XML by trying to open it it IE. If there are XML error IE will complain.



karthik

  • Active Member
  • ***
  • Posts: 56
    • View Profile
Re: Userdefined Commands XML file
« Reply #2 on: March 26, 2014, 16:31:47 »
Thanks. Looks like I missed a "/'" in the XML file. Now it works. Opening in IE tip was useful to check if XML was fine.