Multi Commander > Support and Feedback

Bug with build 2222

(1/2) > >>

MikeC:
Just upgraded to build 2222.

This version does not load registry tabs defined with an .ini file in the command line. Instead, all the tabs are for C:\. This worked just fine in the prior version.

Mathias (Author):
Only tab showing REG: that fails ?

I think it has to do with the new FileSystem scanning engine. I will check.

MikeC:
Yes, only registry tabs fail. Tabs for normal folders (a separate invocation of MC) work fine (and faster!).

AlanJB:
I load my tabs from a .mctab file and the REG: tab loads OK...

Mathias (Author):
But if you use a startup file
Eg
MultiCommander.exe -F=MyTabs.ini

It does not work for REG:  , I  Just confirmed it.
It works if the path have been browsed before.. There is an error when going to a subpath on a virtual device where parent folder is not browsed before..  (and REG: is virtual. )
:(

To bad MikeC did not run beta version, then I would  have found this issue before :)

But it is only an issue with startup.. Normaly you will start at REG: and browse you way down. And that work

Navigation

[0] Message Index

[#] Next page