Multi Commander > Beta Releases

Re: Multi Commander 6.9.1

<< < (3/3)

Mathias (Author):

--- Quote from: Ulfhednar on January 28, 2017, 10:46:45 ---Thanks Mathias.
Unfortunately 'save' is grayed out.  I can only save as   :-\
I can add tabs & change paths but MC only gives me save as as an active option.

--- End quote ---
Is a TabSession loaded ? "Save" in only enabled if a tabsession is loaded.

Ulfhednar:
Ahhhh!  That's why. 
I had assumed that when MC loaded it was now loading the tab session last used/defined, rather than recalling it's former settings/placements as normal.
I wonder if MC could be configured to always load tab session XYZ if req'd or maybe would that create too many possible conflicts....

Thanks for enlightening me Mathias ;)

Mathias (Author):
No a Tab Session is something you load.. Just like word does not auto load your last document :)
But you can load it using command line parameters

Ulfhednar:
Thanks
I can think of some uses for session via CLI  ;)

Jungle:
Seems I have finally found why columns are being resized. It is related to columns autoadjusting. Steps to reproduce:

1. Enable Details View.
2. Go to a folder with many files (so the scrollbar is visible).
3. Adjust and remember Name column width (e.g. you may enable free size line as a visual reference).
4. Close MC.
5. Start MC. It sets last widths, then shows scrollbar, readjust column widths and so Name column becomes shorter.
6. Repeat steps 4-5. Each time Name column is shortened.

Navigation

[0] Message Index

[*] Previous page