Multi Commander > Support and Feedback

File operations

(1/2) > >>

Jungle:
Security

1. Whatever i select in 'Add file/folder permissions', i get full control
2. If i apply 'Take ownership' on the file i own, an error appears 'Access Denied! Admin permissions....' If a file has other owner, no error occurs and change is done successfully. Maybe there should not be error message on own files?

--

Encoding/Decoding

File panel is not refreshed after ecnode/decode operations

--
MC 1.2.1 b876

Mathias (Author):
1. I will investigate that

2. Not sure if I understand what the problem is.. You get an error message when doing 'take ownership' on a file that you already are owner on ???

Jungle:

--- Quote from: Mathias (Author) on December 02, 2011, 10:47:37 ---2. Not sure if I understand what the problem is.. You get an error message when doing 'take ownership' on a file that you already are owner on ???
--- End quote ---
Yes. You're right. I was confused when tried it several times, because other admin-functions worked well. But then i applied it on the file which had other owner and got success.

Mathias (Author):

--- Quote from: Jungle on December 02, 2011, 11:05:39 ---
--- Quote from: Mathias (Author) on December 02, 2011, 10:47:37 ---2. Not sure if I understand what the problem is.. You get an error message when doing 'take ownership' on a file that you already are owner on ???
--- End quote ---
Yes. You're right. I was confused when tried it several times, because other admin-functions worked well. But then i applied it on the file which had other owner and got success.

--- End quote ---

Im not able to make it fail here. Might be a XP only issue. Will check XP later

Mathias (Author):
Did some tests on Windows XP. But was not able to get any errors.

Navigation

[0] Message Index

[#] Next page