Author Topic: How to keep not reachable path  (Read 11845 times)

cdull

  • Newbie
  • *
  • Posts: 4
    • View Profile
How to keep not reachable path
« on: September 24, 2019, 13:41:59 »
I am new to Multi Commander.

My problem is to keep a unreachable path.

Like i have open 3 paths from a USB flash drive. Now i remove the USB flash drive and restart Multi Commander.

Now i got 3 times "C:\" and my paths are lost.

I found nothing in the settings to change this.

How can i keep the paths and if i click on it i will get a message "the path is not reachable" or something like this - and keep the tab open.

Does anyone know if this is possible with Multi Commander at the moment?

Best Regards
Christian



Jungle

  • Contributor
  • VIP Member
  • *****
  • Posts: 510
  • Old Skull
    • View Profile
Re: How to keep not reachable path
« Reply #1 on: September 24, 2019, 15:03:40 »
Go to Menu Configuration > Explorer Panel Settings, then Display tab, scroll to Save on exit
Try uncheck Remember only paths to local harddrives

cdull

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: How to keep not reachable path
« Reply #2 on: September 26, 2019, 17:54:01 »
That is what i found before i created this post, but that is not working. It resets to c:\ if the drive is not connected

Mathias (Author)

  • Administrator
  • VIP Member
  • *****
  • Posts: 4271
    • View Profile
    • Multi Commander
Re: How to keep not reachable path
« Reply #3 on: September 27, 2019, 08:08:31 »
No if a local drives does not exists then it can't show it, it will revert back to C:\ 
else it would show a empty panel. and that is not good.

You can have a TabSession with settings for when the drive is connect and swap to that when the drive is connected

cdull

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: How to keep not reachable path
« Reply #4 on: September 27, 2019, 11:17:25 »
In the past i used QTTabbar (tabs in Windows Explorer) There is see the name of a tab and when i click on it, i get a popup message that says "path xy is not reachable". After i press "ok" it closes the popup and tab.

This would also the best solution at multi commander for me

Mathias (Author)

  • Administrator
  • VIP Member
  • *****
  • Posts: 4271
    • View Profile
    • Multi Commander
Re: How to keep not reachable path
« Reply #5 on: September 27, 2019, 12:25:43 »
I don't think that would be a good solution. if the drive are gone it is gone. And showing message boxes is not a good solution
It would also not fit inte the architecture on how MC works.

cdull

  • Newbie
  • *
  • Posts: 4
    • View Profile
Re: How to keep not reachable path
« Reply #6 on: September 27, 2019, 17:08:51 »
Thanks for reply.

There are many ways to deal with the problem for me (with a little bit afford)

1. Use tab sessions
2. Save open tabs as files and load them (when i lost some tabs)
3. Open multi commander only when the drive is connected