Multi Commander > Support and Feedback

Copy: rename and append greyed out

(1/2) > >>

Fufurro:
Hello! I'm using multicommander for quite a while now, and I just noticed that in the copy/overwrite popup the options to rename and append files are greyed out.
Is there a setting that I can change to enable these functions?

I'm using the latest version on Windows 10.

Thanks in advance!

Mathias (Author):
Normally they are enabled. But depends on device type of source and target volume

Fufurro:
After additional testing, I report the following:

when moving a file in another location of the same partition and in the destination folder the same file is already present, the options to rename and append are greyed out.


Is there anything I might change in the settings or is it something you will investigate?
Thanks

Fufurro:
Bump

The previous message might have been lost in summertime :-)

As mentioned, the behaviour appears when moving files on the same partition (not a copy, a move). Anything I should check or it is something that you might look into at some point?
Thanks!!

Mathias (Author):
No there is no setting for that.
I think it is because it is a move on same disk it already entered into a rename operation so data is never copied. so then it cant append

Navigation

[0] Message Index

[#] Next page