Multi Commander > Support and Feedback

MC not starting after updating to v16.0 (build 3186)

<< < (2/2)

ncodina:

--- Quote from: Mathias (Author) on July 13, 2026, 11:25:42 ---16.1 out now. It should now load config file using UTF8 encoded path. so it is not fail on path containing special characters

--- End quote ---
Thank you! Now it kinda starts. I'm not getting the previous error message, but it looks like it cannot read or save the config files. It says Access Denied, even if I run it as admin.

Mathias (Author):
Might be that it got corrupted when it did not work before. or something else has the file open so it cant resave it

Mathias (Author):
build 3189 was bad. not all new files in the release was correct version. so there is a 3890 that should be correct..

ncodina:

--- Quote from: Mathias (Author) on July 13, 2026, 13:37:53 ---build 3189 was bad. not all new files in the release was correct version. so there is a 3890 that should be correct..

--- End quote ---
Hi Mathias, I can confirm build 3890 was installed and ran correctly. Now I just need to configure it all over again  :D

Thanks for your support.

Navigation

[0] Message Index

[*] Previous page