Messages

1

Support and Feedback / Re: How to keep not reachable path

« on: September 27, 2019, 17:08:51 »

Thanks for reply.

There are many ways to deal with the problem for me (with a little bit afford)

1. Use tab sessions
2. Save open tabs as files and load them (when i lost some tabs)
3. Open multi commander only when the drive is connected

2

Support and Feedback / Re: How to keep not reachable path

« on: September 27, 2019, 11:17:25 »

In the past i used QTTabbar (tabs in Windows Explorer) There is see the name of a tab and when i click on it, i get a popup message that says "path xy is not reachable". After i press "ok" it closes the popup and tab.

This would also the best solution at multi commander for me

3

Support and Feedback / Re: How to keep not reachable path

« on: September 26, 2019, 17:54:01 »

That is what i found before i created this post, but that is not working. It resets to c:\ if the drive is not connected

4

Support and Feedback / How to keep not reachable path

« on: September 24, 2019, 13:41:59 »

I am new to Multi Commander.

My problem is to keep a unreachable path.

Like i have open 3 paths from a USB flash drive. Now i remove the USB flash drive and restart Multi Commander.

Now i got 3 times "C:\" and my paths are lost.

I found nothing in the settings to change this.

How can i keep the paths and if i click on it i will get a message "the path is not reachable" or something like this - and keep the tab open.

Does anyone know if this is possible with Multi Commander at the moment?

Best Regards
Christian