Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: andrew on January 29, 2016, 02:08:16

Title: Bug - tabs for removable or network locations not remembered
Post by: andrew on January 29, 2016, 02:08:16

Hello,
I have been trying out MultiCommander - it looks pretty good. I think I have found a bug: if I have tabs open that point to a removable drive (USB flash disk, SD card) or a network share, and then close MultiCommander and re-open it, all of those tabs revert to C:\ instead of the proper location.

Thanks for a good program.

Title: Re: Bug - tabs for removable or network locations not remembered
Post by: Jungle on January 29, 2016, 05:43:36

It's not a bug. By default MC only saves local paths. Saving all paths can be toggled via Explorer Panel Settings > Display > Save on exit > Save only paths to local harddrive option.

Title: Re: Bug - tabs for removable or network locations not remembered
Post by: andrew on January 31, 2016, 23:24:15

Great. Thanks for replying.

Title: Re: Bug - tabs for removable or network locations not remembered
Post by: papi on April 24, 2016, 17:07:45

Quote from: Jungle on January 29, 2016, 05:43:36

It's not a bug. By default MC only saves local paths. Saving all paths can be toggled via Explorer Panel Settings > Display > Save on exit > Save only paths to local harddrive option.

This solution does not work to me (NAS location).

Title: Re: Bug - tabs for removable or network locations not remembered
Post by: Mathias (Author) on April 24, 2016, 17:55:30

If you disable that option, then it will not filter away remote device on close.
If they are not shown on next startup then MC could not find them at start up. And then maybe the NAS is not accessible at that time or something.