1
Support and Feedback / Storing of last configuration / panel view
« on: August 20, 2015, 07:58:14 »
Hello,
I am new and try to get an overview about the MultiCommander functions.
I have two questions:
1.
MC shows always the Dual Panel view if I start it.
Is it possible that I get just a One Panel view when I start the program?
I was surprised that I don't get the last selected panel view after starting.
2.
I haven't found a way to customize the tool bar. Are the icons/functions fix in this bar?
No possibility to move or add something?
Thank you for your help in advance.
Bernhard
I am new and try to get an overview about the MultiCommander functions.
I have two questions:
1.
MC shows always the Dual Panel view if I start it.
Is it possible that I get just a One Panel view when I start the program?
I was surprised that I don't get the last selected panel view after starting.
2.
I haven't found a way to customize the tool bar. Are the icons/functions fix in this bar?
No possibility to move or add something?
Thank you for your help in advance.
Bernhard