Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: pncdaspropagandas on August 04, 2017, 20:16:38

Title: Session, save & mapped network folder
Post by: pncdaspropagandas on August 04, 2017, 20:16:38

Hi,

I don't know if it is a matter of not supported yet, a intended way of working or a bug...

I have a mapped network folder on P:\ (for example \\my_server\dir1)

Then I open MC and navigate to P:\dir2

When I close MC and open it again, all other tabs that were sitting o local hard disks are restored gracefully, but the one I had on P:\dir2 is resetted to C:\

I noted that the file at mcinstallpath\SessionConfig\History\a4c.....ini really has a C:\ on the corresponding tab config. When I change the directory on the other tabs and go to the command line and execute :save the ini file is updated but the tabs showing network mapped paths still show C:\

I also noted that if I create a Tab Session and save it, when I restore it works with mapped network paths ok.

Title: Re: Session, save & mapped network folder
Post by: Jungle on August 04, 2017, 21:35:06

By default MC doesn't save network paths on exit. Check the following setting:
Explorer panel settings > Display > Save on exit > Remember only paths to local harddrive

Title: Re: Session, save & mapped network folder
Post by: pncdaspropagandas on August 05, 2017, 15:21:25

Thank you very much Jungle!!!  :D