Messages

1

Support and Feedback / Re: Storing of last configuration / panel view

« on: August 20, 2015, 12:26:49 »

Understood!
Thank you for your quick response Mathias.

Best Regards
Bernhard

2

Support and Feedback / Storing of last configuration / panel view

« on: August 20, 2015, 07:58:14 »

Hello,
I am new and try to get an overview about the MultiCommander functions.
I have two questions:

1.
MC shows always the Dual Panel view if I start it.
Is it possible that I get just a One Panel view when I start the program?
I was surprised that I don't get the last selected panel view after starting.

2.
I haven't found a way to customize the tool bar. Are the icons/functions fix in this bar?
No possibility to move or add something?

Thank you for your help in advance.

Bernhard