Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: wuildara on October 17, 2013, 18:32:04

Title: skiip does not work
Post by: wuildara on October 17, 2013, 18:32:04

when copying a lot of files, there is sometimes the question if an existing files should be overwritten or skipped, etc.
Choosing skip generates the following scenario.

1. The requested file is skipped.
2. the following file will be copied to "Nirwana". That means the bytecount runs, but in the source directory you can see, that there are not data arrived.
3. the time for copying grows to indefinitly
4. The only way to exit, is to cancel the whole operation.

Can somebody explain me this?

Thanks
wuildara

Title: Re: skiip does not work
Post by: Mathias (Author) on October 17, 2013, 22:01:24

I never seen that behavior.
Do you get any file operations errors in the log windows (Ctrl+L)
if the target/source local hardrives/network/other.