Print Page - How to go to the disk root on tab changing automatically?

Title: How to go to the disk root on tab changing automatically?
Post by: AndreWin on August 18, 2015, 13:23:17

Hello!

I created new tab - disk C. Then I choosed disk D. I went not to the root of disk D but to the folder on D in which I was before.
Is there anything setting to go to root of disk automatically?

Best regards, Andrey.

Title: Re: How to go to the disk root on tab changing automatically?
Post by: Mathias (Author) on August 19, 2015, 09:12:39

Sorry No.

It goes to the last location in that drive from current session.
This way you can go to a location in a another tab fast.
Ctrl+BackSpace or click on GoToRoot icon will take you to the root.

Title: Re: How to go to the disk root on tab changing automatically?
Post by: PythonCA on September 10, 2015, 19:10:22

Unless you want to system driver; double click on tab bar, then the new tab will take you to the C:\. Ctr+Tab leads you rather to the last location.

Multi Commander Support Forum

Multi Commander => Support and Feedback => Topic started by: AndreWin on August 18, 2015, 13:23:17