News:

MultiCommander v16.6 is released!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Lance

#1
Support and Feedback / Re: Cannot run MC
May 25, 2014, 19:18:59
I've found that the only way to run the later versions of MC is to stop my Internet Security program! But as I am usually connected to the Internet I can't keep that up. So for the present time I've given up trying to use it.
#2
Support and Feedback / Re: Cannot run MC
May 01, 2014, 15:14:43
Problem again!

I exited MC then put PC into stand-by.

When I woke up the PC  and restarted MC ; it loaded up and then stated that it had stopped working and gave me the same message that it did initially.

This time I've save the files referred to:

" Files that help describe the problem:
   C:\Users\Lance\AppData\Local\Temp\WER2234.tmp.WERInternalMetadata.xml
   C:\Users\Lance\AppData\Local\Temp\WER2E08.tmp.appcompat.txt
   C:\Users\Lance\AppData\Local\Temp\WER2E28.tmp.hdmp "

Every time it stops the reported files are basically the same only differing in the prefix "WERxxxx. "


I've attached the WER2E08 file.
#3
Support and Feedback / Re: Cannot run MC
May 01, 2014, 11:47:39
I've just tried the 3.5 version installation again... and it went without a hitch!!!

I've just built a new computer using an Asrock Extreme4-M m'bd and an Intel i5-3450 cpu which runs superbly.

I don't know why the previous times were a problem; it got through to asking which control interface I wanted, either Windows or Commander and then said something about unable to complete installation and removed all the files!

Anyway, now I can proceed to use it.
#4
Support and Feedback / Cannot run MC
April 25, 2014, 17:50:22
Windows says there is a problem but does not give anymore information.
I've tried download all the available versions, both the 64 and 32 bit , to no avail.

I'll try a two year old version and up-date the post.