News:

MultiCommander v16.6 is released!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - shekky

#1
I had to re-connect the drive in windows before it would show up, which is strange because there are other disconnected network drives that do in fact show up in the toolbar.
#2
I have a few mapped drives, but the last one (Z:) is not longer showing up in the drive toolbar.
I have the toolbar set to show on a separate line to make sure there is enough room for all the drives to show up.
I even removed a virtual drive that I had to see if there were maybe too many drives to for multi-commander to handle, but no luck.
It used to show up an update or so ago, but now it doesn't show up. This is a mapped network drive if that matters.
#3
Looks like this issue is fixed now.
#4
Is there a way to have MultiCommander connect to a disconnected network drive? Currently I have to open it in windows explorer before MultiCommander will be able to browse the network share. I suppose windows explorer is passing authentication credentials or whatever and so MultiCommander cannot browse to it until it is connected. I thought maybe there ways a way to use the windows shell to do this or maybe there is a setting that I am unaware of. Thanks.