News:

MultiCommander v16.6 is released!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - cdull

#1
Thanks for reply.

There are many ways to deal with the problem for me (with a little bit afford)

1. Use tab sessions
2. Save open tabs as files and load them (when i lost some tabs)
3. Open multi commander only when the drive is connected
#2
In the past i used QTTabbar (tabs in Windows Explorer) There is see the name of a tab and when i click on it, i get a popup message that says "path xy is not reachable". After i press "ok" it closes the popup and tab.

This would also the best solution at multi commander for me
#3
That is what i found before i created this post, but that is not working. It resets to c:\ if the drive is not connected
#4
Support and Feedback / How to keep not reachable path
September 24, 2019, 13:41:59
I am new to Multi Commander.

My problem is to keep a unreachable path.

Like i have open 3 paths from a USB flash drive. Now i remove the USB flash drive and restart Multi Commander.

Now i got 3 times "C:\" and my paths are lost.

I found nothing in the settings to change this.

How can i keep the paths and if i click on it i will get a message "the path is not reachable" or something like this - and keep the tab open.

Does anyone know if this is possible with Multi Commander at the moment?

Best Regards
Christian