Multi Commander > Support and Feedback

Program hangs at "Reading MultiCommander Configuration"

(1/3) > >>

pyroguy7:
While trying to run MultiCommander (v11.0, build 2770) the popup window reports "Reading MultiCommander Configuration", but then never moves past this and hangs indefinitely.

Anyone else experience this?  I've also uploaded a .DMP file in hopes that someone can take a look and see why it's hanging.

shadonoz:
I am having the same problem, except MC does start after about 20 seconds.

The log shows:  2021-05-04 15:21:46.581 Dropbox appdata folder not found : "C:\Users\Dean\AppData\Roaming\Dropbox"
                        2021-05-04 15:21:46.581 GoogleDrive folder not found : "<empty>"

I do NOT use Google drive nor Dropbox.  How can I remove these from the configuration file?

Thanks.

shadonoz:
UPDATE:  I deleted TabSessions.xml from C:\Users\Dean\AppData\Roaming\MultiCommander\Config\

And so far, that has solved the problem.  And that file has NOT been recreated.

shadonoz:
NEW UPDATE:  The fix only lasted one restart.  Now it's taking over a minute looking for those same folders mentioned above.
How can I get MC to stop looking for those non-existent folders?
Thanks!
Win 10 Home 20H2 build 19042.928

BTW, my boot drive is an SSD.  Previously, MC would start within just a couple of seconds.

shadonoz:
SOLUTION: It was a mapped network drive.  Whenever that system was offline, MC would hang looking for the drive. I have to disconnect from that drive.  When I am disconnected, MC starts normally.
Sounds like a Windows bug, since it didn't used to behave that way.

Navigation

[0] Message Index

[#] Next page