Use of ONLYFILES & ONLYFOLDERS Commands

[blitz999]

Hi,
I've just started using Multi Commander and I am trying to setup buttons to emulate two functions found in Total Commander. These are, 'Select all Files' and 'Select all Folders'. I found an old post stating the two options (ONLYFILES  & ONLYFOLDERS) would be created to accomplish this. Although I have found those two options, I have so far been unable to successfully accomplish this using the MC.Explorer.Select or MC.Explorer.Selection.Select. parameters. I have also been  unable to find examples of these two options in the Multi Commander documentation or on this forum.
Any examples would be greatly appreciated.

Thanks in advance.

[Jungle]

Try adding

Code Select Expand

FILTER=*

So the command should look like

Code Select Expand

MC.Explorer.Select ONLYFOLDERS FILTER=*

[blitz999]

Thanks Jungle,

Your solution worked
I was placing the "FILTER" option ahead of the "ONLYFILES" & "ONLYFOLODERS" options
Thanks once again for your quick reply!